PATENTED SYSTEM
• Cutting
• Micronization of plants (in the object of an extraction)
Mixing 2 blades
160 mm : PC012
190 mm : PC013
This statif is intended to be associated only with the following MISCEO blockmotors : PC145 or PC165. Any other association shall make the person making the association responsible for compliance with the safety requirements in accordance with the regulations in force.
The Spiral Stirrer is used at a low to medium speed in medium to high viscosity fluids. With an axial flow (drawing from the bottom to the top) the Spiral Stirrer is ideal for homogenous mixing and for cooldown phases with heat exchange from bottom to top. The Spiral Stirrer is very good for even distribution of particles (ex exfoliating beads, active particle beads) and pigments throughout a product. Can be used with sensitive materials. Suitable for emulsions, suspensions, gels, color cosmetics.
Mixing blades
PC051 : 400 mm
PC055 : 300 mm
COMPLETE SET : Dissolver + Propeller 4 blades + Spiral + Anchor for range 300 P/F
Important notification : if you purchased a turbo agitator tool from 300 range (ref. PC038) prior to 01/05/2024, the complete set will not fit. You will need to purchase the new generation reduction box PC038.0.
Mixing 4 blades
160 mm : PC022
190 mm : PC023
Mixing 2 blades
160 mm : PC012
190 mm : PC013
The Dissolver/Dispersion Tool with medium/high shear is used at a medium to high speed in low viscosity fluids to reduce particle size and break down agglomeration (clumping of particles forming a mass). With a radial flow (drawing from both the top and the bottom) this medium/high shear tool creates high turbulence and is ideal for particle fragmentation and dispersion. Ideal in low viscosity for dissolution of powders, homogenous pigment dispersion and use with materials that are not shear sensitive. Once particle reduction and agglomeration break down has been achieved you may choose to continue with a lower shear tool such as the Turbo Agitator Tool, the Anchor Stirrer or the Spiral Stirrer for the remainder of your product.
This statif is intended to be associated only with the following MISCEO blockmotors : PC145 or PC165. Any other association shall make the person making the association responsible for compliance with the safety requirements in accordance with the regulations in force.
This motor block is intended to be associated only with the following MISCEO support : SC060, SC080 or SC090. Any other association shall make the person making the association responsible for compliance with the safety requirements in accordance with the regulations in force.
PATENTED SYSTEM
en