MIXING 2 BLADES TOOL ALL STAINLESS STEEL MISCEO 250 - 160 mm

This motor block is intended to be associated only with the following MISCEO support : SC060, SC080 or SC090. Any other association shall make the person making the association responsible for compliance with the safety requirements in accordance with the regulations in force.

Mixing 4 blades 

160 mm : PC022

190 mm : PC023

Up to 4L

The Turbo Agitator Tool is an excellent all-round tool for most general low shear stirring requirements and ideal for using with shear sensitive materials and mixing surfactants. With an axial flow (drawing from the bottom to the top) it can be used from low speed through to high speed, for low through to medium viscosity fluids. When creating surfactant type products (shampoos, body washes) it is best to commence on low speed to minimise foaming. Medium to high speed is suitable for emulsions, suspensions, oleogels, cooldown phases and other products requiring general stirring.

Low Shear

Low to High Speed

Low to Medium Viscosity

Axial Flow

Mixing 3 blades

Cisailleur 2 lames

160 mm : PC012

190 mm : PC013

The Dissolver/Dispersion Tool with medium/high shear is used at a medium to high speed in low viscosity fluids to reduce particle size and break down agglomeration (clumping of particles forming a mass). With a radial flow (drawing from both the top and the bottom) this medium/high shear tool creates high turbulence and is ideal for particle fragmentation and dispersion. Ideal in low viscosity for dissolution of powders, homogenous pigment dispersion and use with materials that are not shear sensitive. Once particle reduction and agglomeration break down has been achieved you may choose to continue with a lower shear tool such as the Turbo Agitator Tool, the Anchor Stirrer or the Spiral Stirrer for the remainder of your product.

Mixing 2 blades

160 mm : PC012

190 mm : PC013

Mixing 2 blades

160 mm : PC012

190 mm : PC013

The Anchor Stirrer is used at a low speed in high viscosity fluids. With a tangential flow (moving fluid horizontally around the vessel) the Anchor Stirrer will not break/damage sensitive materials and is ideal for the distribution of high mineral content in fluids. Suitable for emulsions, suspensions, gels, colour cosmetics. Can be used with products that contain large particles or beads that you do not want to be broken. With little vertical flow you may use the anchor stirrer at very low speed for higher viscosity surfactant formulations (shampoos, body washes etc) to minimise foaming.