VACUUM PUMP MISCEO 250

Mixing blades

PC051 : 400 mm 

PC055 : 300 mm 

Mixing 4 blades 

160 mm : PC022

190 mm : PC023

Important notification : if you purchased a turbo agitator tool from 250 range (ref. PC018) prior to 01/05/2024, the spiral tool will not fit. You will need to purchase the new generation reduction box PC018.0.

This statif is intended to be associated only with the following MISCEO blockmotors : PC145 or PC165. Any other association shall make the person making the association responsible for compliance with the safety requirements in accordance with the regulations in force.

Mixing blades

PC051 : 400 mm 

PC055 : 300 mm 

The Anchor Stirrer is used at a low speed in high viscosity fluids. With a tangential flow (moving fluid horizontally around the vessel) the Anchor Stirrer will not break/damage sensitive materials and is ideal for the distribution of high mineral content in fluids. Suitable for emulsions, suspensions, gels, colour cosmetics. Can be used with products that contain large particles or beads that you do not want to be broken. With little vertical flow you may use the anchor stirrer at very low speed for higher viscosity surfactant formulations (shampoos, body washes etc) to minimise foaming.

Up to 4L

The Turbo Agitator Tool is an excellent all-round tool for most general low shear stirring requirements and ideal for using with shear sensitive materials and mixing surfactants. With an axial flow (drawing from the bottom to the top) it can be used from low speed through to high speed, for low through to medium viscosity fluids. When creating surfactant type products (shampoos, body washes) it is best to commence on low speed to minimise foaming. Medium to high speed is suitable for emulsions, suspensions, oleogels, cooldown phases and other products requiring general stirring.

Low Shear

Low to High Speed

Low to Medium Viscosity

Axial Flow

Vacuum Rotor stator tool 

160 mm: PC014

190 mm: PC015